Black Box Network Hardware EncrypTight Enforcement Point (ETEP) Manual De Usuario
ET0100A Physical Description
ETEP Installation Guide
15
The following table describes how to interpret the LEDs on the ET0100A front panel.
Rear Panel
The ET0100A rear panel is shown in
Figure 7
ET0100A Rear Panel
Table 2
ET0100A Front Panel LED Indicators
Indicator Light
State
Indication
Power (green)
Off
Unit is powered off.
On
Unit is powered on.
Ethernet port status
(green)
a
a. The link status LEDs are on the remote and local data ports, and Ethernet management port.
Off
Loss of signal on the 10/100 link.
On
The link is up but no traffic is passing over the link.
Blinking
Indicates the presence of traffic on the 10/100 link.
Gigabit link status (amber)
Off
Loss of signal on the Gigabit link.
On
The Gigabit link is up but no traffic is passing over the link.
Blinking
Indicates the presence of traffic on the Gigabit link.
Alarm (green)
Off
Normal operation.
On
The unit is in an error state. This occurs when the
diagnostics detect a boot failure, a critical error threshold is
exceeded, or a FIPS test fails when the ETEP is in FIPS
mode.
Diagnostic code display
On
Displays diagnostic codes during boot up. After boot up, it
reflects the operational state of the appliance and error
conditions.
:
1)
Power receptacle
2)
Fan
3)
Product ID label