Black Box Network Hardware EncrypTight Enforcement Point (ETEP) Manual De Usuario
Installing the ET0010A
ETEP Installation Guide
27
The steps to perform for a typical installation are listed below.
Cabling Requirements: ET0010A
outlines the standard cables used with each port on the ETEP. The connector type listed
indicates only what is required to connect to the ETEP port, and may or may not be the same connector
type required for the other end of the cable. Some cables are supplied by Black Box and others are user-
supplied.
type required for the other end of the cable. Some cables are supplied by Black Box and others are user-
supplied.
Unpacking the Shipping Carton: ET0010A
Remove all product components from the shipping carton and compare the contents to the packing list.
Keep all packaging in case it is necessary to return the unit.
Keep all packaging in case it is necessary to return the unit.
The ETEP is packaged with the standard items listed below. Additional cables, country-specific power
cords, and other accessories can be ordered separately.
cords, and other accessories can be ordered separately.
1 ET0010A
●
Firmware and software is factory-installed on the unit.
2 Accessory Kit
●
(1) Power cable (US)
●
(1) Power supply
Table 11
Installation Steps
Step
Action to Perform
Description
1
Review the cabling requirements.
2
Unpack the shipping package.
3
Install the ETEP in a rack or on a solid surface.
4
Connect the cables.
5
Apply power to the ETEP.
Table 12
ET0010A Standard Cables
ETEP Port
Cabling
Supplied by...
Power receptacle
Power supply and power cable
Black Box
RS-232 port
1.8 meter shielded null modem
cable with an RJ45 connector at
one end and a DB9 female
connector at the opposite end.
Black Box
Ethernet Management Port
Unshielded Category 5 straight
through cable (UTP), RJ-45
connector
Black Box
Aux1 port
Not applicable. Port is not
enabled in this release.
Not applicable
Remote and Local ports
(2) Unshielded Category 5
straight through cables (UTP),
RJ-45 connector
a
a. The local, remote, and Ethernet management ports are auto-sensing for polarity. You can use shielded Category 5
straight through cables or crossover cables when connecting to these ports.
User