Bushnell BackTrack D-TOUR (Bear Grylls version) Manual De Propietario

4

•  Unlock/open battery cover and insert 3 AAA batteries* 

(Fig 1, pg 3). Record the serial # inside-you’ll need it 
later to register your D-Tour online. Close the cover. 

•  Go outdoors. HOLD POWER (1) (keep the button 

pressed) until the display comes on. Wait for GPS 
satellite lock (icon stops blinking) (11). This may take 
a few minutes after the first power-up in a new area.

•  Press SETUP (4). Press MARK (2), then press the TRIP 

(3) or SETUP button to set the Hour for your area (Fig. 

2). Press MARK to return to the Setup screen.

•  To change the time and temp/distance formats, press 

SETUP to select “12h” or “

0

F/yd”, then press MARK to 

set to “24h” or “

0

C/m”.  (Fig. 3). The arrow’s function 

is explained on the next page. Press POWER to exit 
Setup screen.

•  Press POWER to select one of five Location icons or up 

to 5 additional locations with number designations 
(6) (Home, Car, Star, Flag, Target, #1-5). While standing 
at the Location you want to mark, HOLD MARK to 
save its position in the D-Tour’s memory (the display 
will change as shown) (Fig. 4). You can now turn the 
power off (HOLD POWER) and leave the location. 

•  To return to the location you marked, turn the D-Tour 

on. Make sure the same icon or # you used to mark 
the location is shown (if not, press POWER to select 
it). The display indicates the direction and distance 
back to the location (Fig. 5). Move in the direction 
of the arrow, watching for the distance to decrease.