Bushnell VOYAGER 78-9540 Manual De Usuario

Thank you for purchasing the Bushnell Voyager Telescope!  Your new telescope has been designed and crafted
with the highest standards so that you may have years of enjoyment and use out of this wonderful window to
the heavens.  This product comes complete with everything you'll need to explore your universe including a
professional primary mirror, precision rack and pinion focusing mechanism, superior all-metal main telescope
tube, and professional quality wide-field 5x24mm finderscope.  Whether you are just starting out in astronomy
or you are an avid astronomer we wish you all the best with your telescope.

Please utilize this manual to its fullest potential by reading it completely before you attempt to assemble and
use your new telescope.  Once assembled, we've included a basic guide on how to get started in astronomy at the
end of this manual.  While this is not a complete guide, it will give you some initial pointers.  As you advance
in ability, we would highly recommend a supplemental star atlas, beginning astronomy guide, moon map, or any
other guide as you travel on your journey through the universe.

1.  Remove all components from the carton and identify all components.

2.  Set-Up Tripod

•

  Select one tripod leg. Loosen 

 and extend the 

Tripod  Leg Middle Section.

Tighten the 

 so that the 

 is securely in place. Repeat for  the

remaining two legs.

 

3.  Attach Mount, Telescope and Finderscope

•

  Locate the 

 

Loosen long bolts at the top of 

Attach the mount  to  the 

as  shown 

(fig.  2).

  and

secure 

  to 

.  Repeat  on  the

remaining two 

. Once you have attached all 

 to the mount, securely tighten all tripod bolts.

•

  Locate  the 

  with  pre-assembled 

 Remove the two nuts located near the front  of  the

telescope (closet to the rack and pinion focuser) and place
the 

  and 

over  the  exposed

screws.  Replace  the  nuts,  and  securely  tighten  the

 and 

 in place.

 

1.  Attach Accessory Tray

•

  Locate  the 

  Using  the  accessory  tray

bolts, wingnuts and washers connect the 

Accessory Tray   

to

the

  Accessory Tray  Braces

.  Start  with  one  tripod  leg  and  attach  wingnuts.  Wingnuts  should  be

positioned beneath the accessory tray. Do not tighten wingnuts until all 

 are

attached as some adjustments may be required.

 

2.  Attach Control Cables, Counterweight and Eyepieces

•

  Locate the 

Loosen  the  silver  screws  located  at  the  end  of  the 

and attach the

 to the two silver posts found on the 

.

 
3.  Locate  the 

  and 

  Loosen  the  thumb  screw  located  on  the

 and slide the 

 onto the 

 then and tighten thumb screw to

secure the  

. Thread the 

 into the hole located at the bottom of the "L"

shaped bend in the 

 .  Make sure that the shaft is securely  locked into mount.

 

 

fig. 2