Bushnell 78-9570 Manual De Usuario
STANDARD EQUIPMENT
•
Refractor Telescope Assembly w/Rotary Power® Turret
•
Rotary Power® Turret Includes 4mm, 10mm, and 20mm
eyepieces, 2.5x Barlow, and Moon Filter
•
Exclusive Metal Easy Track® Mount
•
Compact Three-Section Variable Height-Aluminum Tripod
•
Red Dot Finderscope
•
T-18 1.5x Erecting Lens
Fig.1
TELESCOPE ASSEMBLY
1. Your Bushnell Voyager Telescope comes pre-assembled from the factory for quick set-up and use.
Remove all components from the carton and identify all components. It is a good idea to lay all the
parts out in front of you before assembly. READ THROUGH SET-UP INSTRUCTION BEFORE YOU
SET-UP YOUR TELESCOPE
parts out in front of you before assembly. READ THROUGH SET-UP INSTRUCTION BEFORE YOU
SET-UP YOUR TELESCOPE
2. Set-Up Tripod
•
Remove pre-assembled tripod and mount from carton. Loosen the leg section locking screws (2 per leg)
of one leg and gently extend each section to the desired height. Re-tighten locking screws. Repeat on
remaining two legs.
remaining two legs.
3.
Attach Telescope and Finderscope
•
Locate the pre-assembled
Telescope Main Tube (1)
.
Remove
Main Tube Locking Nuts (3)
from screws
extending from bottom of
Telescope Main Tube (1).
Insert extended screws into holes in cradle of
Easy
Track® Mounting System.
Refasten
Main Tube Locking
Nuts (3).
•
Remove plastic insert on bottom side of finderscope to
allow battery to make connection with battery contact
for power. Turn power switch on. See finderscope
page.
for power. Turn power switch on. See finderscope
page.
•
Look through main telescope tube at low power and
establish a well-defined stationary target. Looking
through red dot finderscope, alternate tightening each
adjustment wheel (at rear and left side of finderscope)
until the red dot of finderscope is precisely aligned and
centered on the same object being viewed in main
telescope tube. See finderscope page.
through red dot finderscope, alternate tightening each
adjustment wheel (at rear and left side of finderscope)
until the red dot of finderscope is precisely aligned and
centered on the same object being viewed in main
telescope tube. See finderscope page.
Fig. 2
4.
Remove Lens Covers from
60mm Objective Lens
and each ocular eyepiece contained in
Rotary Power
Turret®.
Your Bushnell Voyager Telescope is now ready to be used. To obtain the fullest
enjoyment from your telescope, please refer to the additional information below.
Accessory Turret
-2.5X Barlow
-Moon Filter
T-18 Slot
4mm, 10mm, 20mm Eyepieces
R