Bushnell 11-0013G Manual De Usuario
22
23
TWO-Year LIMITED WARRANTY
Your Bushnell
Your Bushnell
®
product is warranted to be free of defects in materials and workmanship for
two years after the date of purchase. In the event of a defect under this warranty, we will,
at our option, repair or replace the product, provided that you return the product postage
prepaid. This warranty does not cover damages caused by misuse, improper handling, in-
stallation, or maintenance provided by someone other than a Bushnell Authorized Service
Department.
at our option, repair or replace the product, provided that you return the product postage
prepaid. This warranty does not cover damages caused by misuse, improper handling, in-
stallation, or maintenance provided by someone other than a Bushnell Authorized Service
Department.
Any return made under this warranty must be accompanied by the items listed below:
1) A check/money order in the amount of $10.00 to cover the cost of postage and handling
2) Name and address for product return
3) An explanation of the defect
4) Proof of Date Purchased
5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit,
with return postage prepaid to the address listed below:
1) A check/money order in the amount of $10.00 to cover the cost of postage and handling
2) Name and address for product return
3) An explanation of the defect
4) Proof of Date Purchased
5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit,
with return postage prepaid to the address listed below:
IN U.S.A. Send To:
IN CANADA Send To:
Bushnell Performance Optics
Bushnell Performance Optics
Attn.: Repairs
Attn.: Repairs
8500 Marshall Drive
25A East Pearce Street, Unit 1
Lenexa, Kansas 66214
Richmond Hill, Ontario L4B 2M9
For products purchased outside the United States or Canada please contact your local dealer
for applicable warranty information. In Europe you may also contact Bushnell at:
for applicable warranty information. In Europe you may also contact Bushnell at:
BUSHNELL Performance Optics Gmbh
European Service Centre
MORSESTRASSE 4
D- 50769 KÖLN
GERMANY
Tél: +49 (0) 221 709 939 3
Fax: +49 (0) 221 709 939 8
This warranty gives you specific legal rights.
You may have other rights which vary from country to country.
©2004 Bushnell Performance Optics
Image Size
Megapixels
(approx)
Quality *
Internal
Memory
64 MB
SD Card
2048x1536
3.2
FQ
10 photos
39 photos
NQ
20
79
EQ
41
158
1600x1280
2.1
FQ
16
64
NQ
33
129
EQ
67
259
1280x960
1.3
FQ
26
101
NQ
53
202
EQ
106
405
1024x768
0.8
FQ
41
158
NQ
82
317
EQ
165
634
800x600
0.5
FQ
67
259
NQ
135
519
EQ
271
1038
Photo Storage Capacity Reference
(
max capacity, +/- 2 photos)
* Selects amount of file compression
(jpg ratio)
(FQ=low/EQ=high)
FQ: Fine Quality (1:2.5)
NQ: Normal Quality (1:5)
EQ: Economy Quality (1:10)
(jpg ratio)
(FQ=low/EQ=high)
FQ: Fine Quality (1:2.5)
NQ: Normal Quality (1:5)
EQ: Economy Quality (1:10)
Image Size refers to the pixel
dimensions, or resolution, of the
digital file.
dimensions, or resolution, of the
digital file.
Actual storage capacity will vary
based on content of each photo
file. You may be able to take a few
photos more or less than the listed
average capacity.
based on content of each photo
file. You may be able to take a few
photos more or less than the listed
average capacity.
Use large size and high quality
settings for photos you may want
to enlarge or crop later. If required,
they may also be reduced to a
smaller file size using your photo
software. Use small size and/or low
quality settings if you will only
email, insert into documents, or
make small prints, and do not want
to resize the file later.
settings for photos you may want
to enlarge or crop later. If required,
they may also be reduced to a
smaller file size using your photo
software. Use small size and/or low
quality settings if you will only
email, insert into documents, or
make small prints, and do not want
to resize the file later.
FCC Note:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV
technician for help.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV
technician for help.
The shielded interface cable must be used with the
equipment in order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of FCC Rules.
equipment in order to comply with the limits for a digital
device pursuant to Subpart B of Part 15 of FCC Rules.
Specifications and designs are subject to change without
any notice or obligation on the part of the manufacturer.
any notice or obligation on the part of the manufacturer.
11-0013 1LIM.indd 22-23
9/22/04 4:33:42 PM