Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 Manual De Usuario

Installing a Brocade NetIron XMR 4000 router

4

FIGURE 171 Installing a module in the Brocade NetIron XMR router

NOTE

When inserting the module into the router, make sure that the faceplate doesn’t overlap with 
the faceplate of an adjacent module.

4. Rotate the ejectors flush with the module faceplate to fully seat the module in the backplane. 

Modules have a snug fit for maximum EMI protection.

5. Tighten the screws at each end of the module faceplate by pushing them in and turning them 

clockwise. Complete the tightening process using the flat-blade screwdriver.

Installing Brocade NetIron XMR 4000 router power supplies

You will need a small Phillips or flat-blade screwdriver to install power supplies.

Follow these steps to install a power supply.

1. Remove the power supply slot blank.

2. Remove the power supply from the packaging.

3. Insert the power supply into the empty power supply slot, using the card guides on each side of 

the slot. Slide the card along the card guides until the ejectors on either side of the power 
supply rotate towards the faceplate.

NOTE

Empty power supply slots must be covered with slot blanks.

Do not overtighten screws when installing power supplies.

CAUTION

Carefully follow the mechanical guides on each side of the power supply slot and make sure the 
power supply is properly inserted in the guides. Never insert the power supply upside down.