Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 Manual De Usuario

Chapter

6

Connecting a Router to a Network Device

Assigning permanent passwords

DANGER

By default, the CLI is not protected by passwords. To secure CLI access, it is strongly recommended 
that you assign passwords. 

The CLI contains the following access levels:

•

Privileged EXEC – This level is also called the Enable level and can be secured by a password. 
From this level you can manage files on the management module flash memory or a auxiliary 
flash card in the management module slots 1 or 2, save the system configuration to flash 
memory, and clear caches. 

•

CONFIG – The configuration level. From this level you can configure a system IP address and 
configure routing features. To access the CONFIG mode, you must already be logged into the 
Privileged level of the EXEC mode.

NOTE
You cannot assign a password using the Web management interface. You can assign passwords 
using the IronView Network Manager software if an Enable password for a super user is already 
configured on the device.

You can set the following levels of Enable passwords:

•

Super user – Allows complete read-and-write access to the system. This is generally for system 
administrators and is the only password level that allows you to configure passwords.

NOTE

You must set a super-user password before you can set other types of passwords.

•

Port configuration – Allows read-and-write access for specific ports but not for global 
(system-wide) parameters.

•

Read only – Allows access to the Privileged EXEC mode and CONFIG mode but only with read 
access.

To set passwords, perform the following steps:

1. At the opening CLI prompt, enter enable to change to the Privileged level of the EXEC mode.

Brocade> enable

Brocade# 

2. Access the CONFIG level of the CLI by entering the configure terminal command.