Brocade Communications Systems Brocade MLX Series and Brocade Netlron XMR 53-1002373-02 Manual De Usuario

Installing a Brocade MLXe-4 router

2

5. Rotate the ejectors until they are flush with the module front panel. This action will fully seat 

the module in the backplane.

6. Tighten the screws at each end of the module faceplate by pushing them in and turning them 

clockwise. Complete the tightening process using the flat-blade screwdriver.

7. Enter the write memory command to ensure that the slot will be correctly configured for the 

new module after a reboot.

Brocade(config)# write memory

Write startup-config done.

FIGURE 48

Installing a module

Installing power supplies in a Brocade MLXe-4 router

You need a small Phillips or flat-blade screwdriver to install power supplies.

Follow these steps to install a power supply.

1. Remove the power supply slot blank and store it for future use.

2. Remove the power supply from the packaging.

3. Insert the power supply into the slot and slide it along the guides on each side of the slot. Refer 

to 

NOTE

Empty power supply slots must be covered with slot blanks.

NOTE

Do not overtighten screws when installing power supplies.

CAUTION

Carefully follow the mechanical guides on each side of the power supply slot and make sure the 
power supply is properly inserted in the guides. Never insert the power supply upside down.