Britax Roundabout Manual De Usuario

Care and Maintenance

Child Seat Cover Removal

Refitting the Cover

To refit the cover, reverse the previous directions. Make sure the

shoulder straps are properly threaded through the chest clips and

the harness is not twisted.
Cleaning the Cover

HAND WASH using cold water and mild soap.

LINE or LIE-FLAT DRY to prevent cover from shrinking.

DO NOT

bleach, machine wash, machine dry or iron.

Cleaning the Shell

SPONGE CLEAN using warm water and mild soap.

TOWEL DRY

DO NOT

use solvents, abrasive cleaners or disassemble the

harness.

Cleaning the Harness

SPONGE CLEAN using warm water and mild soap.

TOWEL DRY

DO NOT

bleach, machine wash, machine dry or disassemble

the harness.

•

WARNING!

Do not take apart or attempt to take apart

the harness. Never remove the buckle tongues from the

harness. They cannot be reattached after removal. If assembled

incorrectly, the child seat may not perform as intended.

Loosen the harness by pressing the harness

adjuster button while pulling the shoulder

straps forward as far as possible.

Unhook the shoulder straps from the harness

yoke on rear of child seat (Fig. A).

Pull the upper harness straps through the

shell and cover to the front of child seat.

Gently remove the upper portion of the

cover. Be careful not to damage the energy-

absorbing foam.

Remove the buckle and belly pad by turning

the metal buckle strap retainer of the buckle

on the underside of the child seat so the

short side will slide through the child seat

shell (Fig. B).

Push the retainer through the slots in the shell and cover to the

top of the child seat.

Pull the lower harness straps, buckle tongues, and chest clip

through lower slots in cover.

Remove the entire cover from child seat.

For additional demonstration please visit www.BritaxUSA.com.