Britax Diplomat Manual De Usuario
20
Figure A illustrates a typical forward-facing lap/
shoulder-belt installation.
When not in use, always store LATCH connectors in
storage slots.
Place child restraint forward facing on
vehicle seat.
Restraint can be used in recline position when
installed in forward-facing mode with children up
to 40 pounds (18 kg.).
Britax recommends use of Versa-Tether® to
improve installation. If using Versa-Tether
®
(see
pages 23-26), locate tether on rear of restraint
and place up and over seat back while securing
restraint.
Pull the vehicle belt out, then pass it through
both forward-facing belt slots (
Fig. B
).
Verify that the vehicle belt is not twisted, then
buckle (
Fig. C
).
Rotate the lock-off lever downward to open
(
Fig. D
).
Only use lock-off farthest from where the vehicle
belt is buckled.
Push child restraint into the vehicle seat while
pulling the shoulder portion of the vehicle belt
tightly through the lock-off to remove slack.
•
•
1�
•
•
2�
3�
4�
•
5�
Lap/Shoulder Belt Installation
Installation: Forward Facing
B
C
A