Breckwell LUXURY SERIES P2000 Manual De Usuario

FAILURE TO CLEAN AND MAINTAIN THIS UNIT AS INDICATED 
CAN RESULT IN POOR PERFORMANCE AND SAFETY HAZARDS. 
NEVER CLEAN WHEN HOT. 

NOTE: Inspect burn pot periodically to see that holes have not 
become plugged, if so, clean thoroughly. 

 

 

Ashes should be placed in a metal container with a tight-fitting lid. 
The closed container or ashes should be placed on a noncombustible 
surface or on the ground, well away from all combustible materials 
pending final disposal. If ashes are disposed of by soil burial or 
otherwise locally dispersed, they should be retained in the closed 
container until all cinders have thoroughly cooled. 

 

 

The P2000 Freestanding has an ash bin located below the firebox. 
To remove ashes: 

 

a. 

Make sure fire is out and firebox is cool. 

 

b. 

With the door closed clean heat exchanger tubes. 

        (See “CLEANING” and Figure 22). 

 

c. 

Open door and remove the optional imitation log set, if in use. 
Remove burn pot by grasping it and pulling straight out. 

 

d. 

Empty ashes from burn pot into the pedestal ash bin through the 
opening in the bottom of the firebox. Scrape burn pot with 
cleaning tool. Make sure burnpot holes are not plugged. 

 

e. 

Scrape ash in firebox into the pedestal ash bin through the 
opening in the bottom of the firebox (see Figure 23) or vacuum 
to remove ashes. 
WARNING: Make sure ashes are cool to the touch before                    
                   using a vacuum. See “VACUUM USE”. 

 

f. 

Periodically remove and empty ash bin (see Figure 24) by 
unscrewing the two knobs on the front of the pedestal below the 
ash lip. Dispose of ashes properly. 

        (See “ASH REMOVAL” above) 

 

g. 

Replace ash bin, making sure to tighten the knobs and 
maintaining a good seal. 

 

h. 

Replace burn pot. Make sure it is level and pushed all the way 
back in when it is reinstalled. If the collar on the burnpot 
attached to the fresh air tube is not pushed back to meet the 
firebox wall, the Hot Rod will not work properly. 

 

 

Remove ashes periodically as they fill the firebox. To remove ashes: 

 

a. 

Make sure fire is out and firebox is cool. 

 

b. 

With the door closed clean heat exchanger tubes. 

        (See “CLEANING” and Figure 22). 

 

c. 

Open door and remove the optional imitation log set, if in use. 
Remove burn pot by grasping it and pulling straight out. 

 

d. 

Empty ashes from burn pot. Scrape burn pot with cleaning tool. 
Make sure burnpot holes are not plugged. 

 

e. 

Use small shovel or vacuum to remove ashes. 

        WARNING: Make sure ashes are cool to the touch before       
                           using a vacuum. See “VACUUM USE”. 

 

f. 

Replace burn pot. Make sure it is level and pushed all the way 
back in when it is reinstalled. If the collar on the burnpot 
attached to the fresh air tube is not pushed back to meet the 
firebox wall, the Hot Rod will not work properly.