Braun 3775 Manual De Usuario

5

trimmer 

= The long hair trimmer is activated (for trimming sideburns, 

moustache and beard) (c).

If the batteries are discharged, you may also shave with the shaver connected 
to the mains (100–240 V ~). (If the shaver should not run immediately, charge 
it with the switch position «off» for approx. 1 minute.)

•

After shaving, switch the shaver off. Press the release buttons, take off the 
shaver foil (d) and gently tap it out on a flat surface (e).

•

Then thoroughly clean the cutter block with the brush (f). About every four 
weeks, clean the cutter block with Braun cleaning agents (g).

•

Do not clean the shaver foil with the brush.

•

If you have a very dry skin and you notice a reduced operation time of the 
shaver, you should put a drop of light machine oil onto the InterFace trimmer 
and shaver foil (g).

•

To maintain 100% shaving performance, replace your foil and cutter block at 
least every 18 months or when worn. Change both parts at the same time for 
a closer shave with less skin irritation. 
(Shaver foil and cutter block: part no. 3000)

•

Press the release buttons, take off the shaver foil. Replace the new shaver foil 
in the right direction until it locks in place.

•

To remove the cutter block, lift it off (g). 

•

To replace the cutter block, snap onto the holding studs.

•

In order to optimise the capacity and life of the batteries, the shaver should be 
fully discharged through regular use every 6 months approximately. Then 
recharge to full capacity again. This reconditions the rechargeable batteries.

• We recommend that you shave before washing, as the skin tends to be 

slightly swollen after washing.

• Hold the shaver at right angles (90°) to the skin.
• Stretch your skin and shave against the direction of beard growth.
• To maintain 100% shaving performance, replace your foil and cutter block 

at least every 18 months or when worn. 

5635304_IF3775/70_S4_54  Seite 5  Freitag, 24. März 2006  8:54 08