Bosch 24" Compact Condensation Dryer Axxis WTB86202UC Manual De Propietario

31

The Check drain indi-

cator light up.
Water has not drained 

completely.

Drain hose is blocked.

Check drain hose. 
~ Maintenance of drain hose; Page 29
Check drain hose connection conditions. 

Drain hose is leaking: is not 

screwed on the tight at both ends, 

or rubber not placed in hose.

Check the drain hose, be sure that it is on the dryer 

securely with the clamp in place; may need to replace 

the drain hose if leaking continues.

Water is leaking out.

Dryer is not leveled.

Level the dryer. 
~ Leveling the dryer; Page 14

The heat exchanger seal is dirty.

Clean the heat exchanger seal. 
~ Cleaning the heat exchanger; Page 28

Program terminates 

shortly after starting.

Ambient temperature greater than 

41

°

F/5

°

C.

Ventilate the room.

Laundry is not loaded.

Load the laundry. 
~ Loading the laundry; Page 25

Load too small for selected pro-

gram.

Use time program. 
~ Program selection table; Page 20

Loaded laundry dry.

Check the loaded laundry. If it is dry, open the door, 

remove laundry and turn program selector to Off.

The door opens by 

itself.

The door not closed properly.

Close the door until a click is heard.

Creasing.

Laundry load exceeded. 
Unsuitable program selected.

Do not exceed the maximum load for selected pro-

gram. Remove items of laundry immediately after the 

end of the program, hang them up and pull into shape. 

Turn program selector to Off. 

Drying result is not sat-

isfactory (laundry feels 

too damp).

Warm laundry may feel damper 

than it really is. 

Remove items of laundry immediately after the end of 

the program and turn the program selector to Off.

The selected program does not suit 

the load. 

Use another drying program or, in addition, select the 

time program. 
~ Program selection table; Page 20

Dryness level is not adjusted. 

Use Dry Level to adjust the dryness level. 

Fine layer of limescale on the 

humidity sensors. 

Clean the moisture sensors. 
~ Cleaning the moisture sensors; Page 29

Program termination e.g. main 

power supply failure, door open or 

maximum drying time reached. 

See the problem(s) mentioned in this table.

Laundry is too wet. 

Spin laundry at higher speed in the washing machine, 

before drying.
Switch off the dryer and switch on again.

Drying time too long.

Lint filter is dirty.

Clean lint filter. 
~ Cleaning the lint filter; Page 27

Insufficient supply of air.
Air inlet possibly blocked.

Ensure that air can circulate.
Do not obstruct the air inlet on the front of the dryer.

Ambient temperature higher than 

95

°

F/35

°

C.

Ventilate the room.

Program does not start 

Finished in (remaining) 

time is displayed.

Program ending time has been 

selected and activated.

Drying cycle will begin at proper time to complete at 

the selected Finished in time.

Program does not start 

- 

D

 symbol light up.

Childproof look is activated.

Deactivate Childproof look. 
~ Childproof lock; Page 26