Bosch Dual-Fuel Slide-In Range Manual De Usuario

Installation

English 12

There are two possible electrical connections:

1. Four wire range cord
2. Three wire range cord

The four wire range cord connection is the recommended method, but where local 
codes permit, three wire connections are also acceptable.

For installations other than those in Canada, connect the range cord at the 
terminal block (See next page for detailed instructions). Access the terminal block 
by removing the cover in the lower right hand corner of the range back panel.

Place strain relief in knockout below terminal block. See Figure 11: Strain Relief 
Knockout.

1. In the knockout panel below the terminal block, remove the knockout that fits 

your strain relief.

2. Feed range cord through hole and strain relief up to terminal block. Allow for 

slack in the cord between the strain relief and terminal block.

3. Once cord length/ slack has been adjusted, attach strain relief per instructions 

included with strain relief.

Note:
In Canada, the range is shipped from the factory with the range cord 
already installed. Continue to “Connect Gas Supply” on page 16.

The strain relief provided with your range cord must be properly 
installed.
Strain reliefs vary. Carefully read and follow the instructions included 
with your strain relief.

Tip:
The knockout panel below the terminal block can be removed from 
the range to install the strain relief: Remove knockout panel from 
range, install strain relief in panel and reattach. DO NOT remove 
entire range back panel.