Bosch Dual-Fuel Slide-In Range Manual De Usuario

Installation

English 16

7. Tighten all connections securely and replace terminal block cover.

8. Properly secure strain relief. See “Install Strain Relief” on page 12 for detailed 

instructions.

Shut off main gas supply valve before disconnecting the old range and leave it off 
until the new hook-up has been completed. Don’t forget to relight the pilot on 
other gas appliances when you turn the gas back on. 

The range can be installed using rigid pipe or a CSA International-certified flexible 
metal appliance connector. If using a flexible connector, always use a new 
connector.

Apply pipe joint compound or Teflon

1

 tape appropriate for use with LP gas and 

Natural gas around all male pipe threads to prevent leaks.

The gas connection is located below the back panel of the range. See “Gas 
Connection Location” on page 16. It is accessible through the drawer access 
panel or from the back of the range. To reach access panel, remove drawer.

The range is shipped from the factory for use with natural gas. For use with 
propane (LP) gas, your range must first be converted using the LP conversion kit.

Note:
DO NOT plug in range at this time.

green ground screw

1.Teflon is a registered trademark of DuPont