BMW K 1100 LT/RS Manual De Usuario
11.18
•
Place the cup spring in position.
•
Insert the freewheel (oiled with engine oil) into the
outer race.
outer race.
•
Install the outer race (with clamp block facing
cover plate); the cup spring must snap into the
outer race.
cover plate); the cup spring must snap into the
outer race.
•
Place the cover plate in position.
X
Tightening torque:
Retaining screws.......................................... 10 Nm
•
Push the freewheel gear on to the layshaft while
turning it clockwise.
turning it clockwise.
•
Push the thrust washer and O-ring on to the lay-
shaft.
shaft.
Removing and installing layshaft nee-
dle roller bearing
dle roller bearing
Removing bearing
•
Heat the bearing seat to 100 °C.
•
Pull out the bearing with counter-support,
BMW No. 00 8 570, and internal puller 21/3,
BMW No. 00 8 574.
BMW No. 00 8 570, and internal puller 21/3,
BMW No. 00 8 574.
•
If the bearing is defective and cannot be pulled
out, carefully cut through the needle roller sleeve
with a grinder.
out, carefully cut through the needle roller sleeve
with a grinder.
Installing bearing
•
Heat the bearing seat to 120 °C.
•
Centre the bearing and drive it in with a
21 mm (0.82 in) drift with a pin of smaller
diameter (15.95 mm/0.628 in).
21 mm (0.82 in) drift with a pin of smaller
diameter (15.95 mm/0.628 in).
LT110190