Blaupunkt BPV 660 Manual De Usuario

E-3

Press the 

PWR

 to turn the unit On or Off.

Rotate the VOL dial to adjust the volume.
It is also possible to set turn-on volume level by following the
procedure explained below.

Rotate the VOL dial until it is set at the required volume.

Volume up

Volume down

Press the 

PWR

 for two or more seconds. The power will

be switched off and the current volume level recorded.

Press 

MUTE / SENS

.

The R-ch/L-ch Level Meter flashes.
To restore the previous volume level, press 

MUTE / SENS

 again.

The clock uses a 12-hour display system.

Turn the ignition key to the ON position.

Press the 

PWR

 to turn on the unit.

Press and hold the 

DISPLAY

 for more than two seconds to

enter the Clock setting mode.

Use the following buttons and dial to set the clock. (The blink-
ing section can be adjusted.)

AUDIO

: To activated Hour blink

MUTE / SENS

: To activated Minute blink

: Adjust the Hour and minute

Press the 

DISPLAY

 momentarily to complete the Clock set-

ting mode.

The display will illuminate showing the time and then auto-
matically shut off after 5 seconds.

Press the 

DISPLAY

 while the ignition switch is in the “ OFF ”

position.

Each time the 

DISPLAY

 is pressed, the display window will

change as shown below ;

Frequency and Clock.

Elapsed time and Clock.

BPV660(EN)_body

1/22/02, 10:48 AM

3