Bissell 3522 Manual De Usuario

 

 

Power cord not firmly plugged in 

 

Check electrical plug.

 

Blown fuse/tripped breaker 

 

Check/Replace fuse or reset breaker.

 

 

Incorrect Height Adjustment 

 

Adjust Powerfoot to correct height setting.

 

Hose not attached to suction opening 

 

Grasp Hose Grip and firmly push onto 

  

 the 

base.

 

Twist 'n Snap Hose not securely attached 

 

Make sure Twist 'n Snap Hose is snapped 

 

 

 

into the locked position.

 

Dust Bag is Full 

 

Replace with new Dust Bag.

 

Rotating Floor Brush bristles worn 

 

Replace brush.

 

Rotating Floor Brush jammed 

 

Remove brush and clean debris from 

  

 brush 

ends.

 

Clog in vacuum 

 

Follow instructions for clearing clogs.

The Hose on the back of the vacuum cleaner that carries 
the dirt from the Powerfoot to the Dust Bag can sometimes 
become clogged. If you notice a change in the sound of the 
vacuum motor, check for clogs.

Unplug cleaner from electrical outlet.

Pull the Bag Door outward to open and set aside. Remove the 
Dust Bag to check the Suction Inlet for a clog.

Grasp the Quick Reach Handle and lift up to separate from 
the Suction Intake Opening. Check for a clog in the Base, the 
Wand or the Hose.

For models with the Twist ‘n Snap Hose. 
Release the hose from the vacuum by turning to 
the right. Straighten the hose and unclog with a long, 
narrow object.

If the clog persists, turn the vacuum cleaner OFF and unplug 
it. Remove the Brush Cover. Check the Air Passageway for 
obstructions. Remove debris from this area. Reposition 
Brush Cover and four screws. Tighten screws securely. 
Make sure end of Brush Cover is snapped into place.

Suction 
Inlet

Air Passageway