Bissell 30C7 Manual De Usuario

w w w . b i s s e l l . c o m   8 0 0 . 2 3 7 . 7 6 9 1

1.  Locate the bag that contains the extension 

wand support, lower cord wrap, and screws. 

Remove the screw packet from the bag.

2.  Stand the vacuum upright and from the 

rear of the unit, slide the base of the 

handle firmly into the grooves at the top of 

the vacuum body.  

3.  Ensure that the handle is firmly attached to 

the vacuum body. The front of the handle 

should be flush with the front of the vacu-

um body.  If there are any gaps, continue 

to push the handle until it is secure.

4.  Remove two of the four screws from the 

screw packet. Insert one screw, into each 

of the existing holes in the handle. With a  

screwdriver, tighten each screw completely.

1.  Locate the bag that contains the exten-

sion wand support, lower cord wrap, and 

remaining two screws.  

2.  Attach the extension wand support to the 

rear of the unit. Extension wand support 

should be placed about half way down 

the vacuum body.  Using one of the two 

remaining screws, insert one screw into the 

existing hole. With a screwdriver, tighten 

screw completely.

3.  Attach the lower cord wrap to the rear of 

the unit. Lower cord wrap should be placed 

toward the bottom of the vacuum body. 

Using the last screw, insert screw into the 

existing hole. With a screwdriver, tighten 

completely.

4a. Attach Twist ‘n Snap

™

 hose by placing the 

tabbed end of the hose into the opening 

of the unit, located on the left side of the 

vacuum (when viewing from the back). Turn 

the hose to the right to lock into place.

4b. Place the attachment end of the hose into the 

hole on the right side of the unit, near the 

wheel.

Do not plug in your vacuum 

cleaner until you are familiar 

with all instructions and  

operating procedures.