Biostar A58M Manual De Propietario
A88M/A78M/A58M
27
4.2 AMI BIOS Beep Code
Boot Block Beep Codes
Number of Beeps
Description
Continuing
Memory sizing error or Memory module not found
POST BIOS Beep Codes
Number of Beeps
Description
1 Success
booting.
8
Display memory error (system video adapter)
4.3 Troubleshooting
Probable Solution
1. There is no power in the system.
Power LED does not shine; the fan of
the power supply does not work
the power supply does not work
2. Indicator light on keyboard does not
shine.
1.
Make sure power cable is securely
plugged in.
plugged in.
2. Replace
cable.
3.
Contact technical support.
System is inoperative. Keyboard lights are
on, power indicator lights are lit, and hard
drives are running.
on, power indicator lights are lit, and hard
drives are running.
Using even pressure on both ends of the
DIMM, press down firmly until the module
snaps into place.
DIMM, press down firmly until the module
snaps into place.
System does not boot from a hard disk
drive, but can be booted from optical drive.
drive, but can be booted from optical drive.
1. Check cable running from disk to disk
controller board. Make sure both ends are
securely plugged in; check the drive type
in the standard CMOS setup.
securely plugged in; check the drive type
in the standard CMOS setup.
2. Backing up the hard drive is extremely
important. All hard disks are capable of
breaking down at any time.
breaking down at any time.
System only boots from an optical drive.
Hard disks can be read, applications can be
used, but system fails to boot from a hard
disk.
Hard disks can be read, applications can be
used, but system fails to boot from a hard
disk.
1. Back up data and applications files.
2. Reformat the hard drive. Re-install
2. Reformat the hard drive. Re-install
applications and data using backup disks.
Screen message shows “Invalid
Configuration” or “CMOS Failure.”
Configuration” or “CMOS Failure.”
Review system’s equipment. Make sure
correct information is in setup.
correct information is in setup.
System cannot boot after user installs a
second hard drive.
second hard drive.
1.
Set master/slave jumpers correctly.
2.
Run SETUP program and select correct
drive types. Call the drive manufacturers
for compatibility with other drives.
drive types. Call the drive manufacturers
for compatibility with other drives.