Bil-Jax Personal Lift AERIAL WORK PLATFORMS Hydraulic Boom Lift Manual De Usuario

3 — OPERATION

3-11

CAUTION

Always remember to unplug the battery charger power cord before moving the
boom lift. Failure to unplug the power cord will cause damage to the equipment.

5. Inspect the charge indicator LEDs near the end of the expected charge cycle. If

all indicator LEDs are off, the battery is fully charged. (The DC ammeter needle
should point to the left.)

NOTE:

The yellow 80% CHARGE indicator lights up when the battery voltage is

charge. At full charge (3-1/2 hours after the 80% CHARGE

hts up), the charger turns off.

use.

3-6 BOOM LIFT TRA

The boom lift trailer is a single axle trailer fitted with a two-inch ball hitch, surge brakes,
brea

lift t
fore towi

hitch, tow, and back the boom lift trailer:

Traile

Trai

give tow vehicle backing instructions.

the ball. Jack up the tongue as needed.

2. Align the ball and hitch (Figure 3-10). Fasten the breakaway safety

cable to the tow vehicle.

nearing full
indicator lig

If the battery voltage does not reach the 80% CHARGE level in 14 hours,

the charger turns off and the red CHECK BATTERY indicator LED
lights up. This prevents extended charging of a faulty battery.

6. Unplug the power cord from the 120 VAC receptacle and the charger recepta-

cle. Properly store the power cord for next

NSPORT

kaway safety cable, safety chains, brake lights, and side marker lights. Proper boom

ransport requires the correct hookup and inspection of these trailer components be-

ng. Use the following procedures to

r Hitching

ler hitching requires a second person to

1. Back the tow vehicle to the trailer. Verify that the ball and hitch are in line and

that the trailer hitch will clear

BREAKAWAY

SAFETY CABLE

JACK IN

RAISED

POSITION

JACK IN

RAISED

POSITION

PIVOT

LOCKING

PO E

PLUG

W R

SAFETY

CHAINS

PARKING

BRAKE

BALL

AND

HITCH

Figure 3-10. Trailer Hitching