Benq W5000 Manual De Usuario

Descargar
Página de 53
44 
Additional information  
Eng
lish
Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please 
install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some 
instances the lamp may explode.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. Turn the 
power off and let the projector cool for 45 minutes. If the Lamp or Temp indicator still lights up after turning the 
power back on, please contact your dealer. See 
"Indicators" on page 47
 for details.
The following Lamp warning displays will remind you to change the lamp.
Replacing the lamp
To reduce the risk of electrical shock, always turn the projector off and disconnect the power cord before 
changing the lamp.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replacing the 
lamp.
To reduce the risk of injuries to fingers and damage to internal components, use caution when removing 
lamp glass that has shattered into sharp pieces.
To reduce the risk of injuries to fingers and/or compromising image quality by touching the lens, do not 
touch the empty lamp compartment when the lamp is removed.
This lamp contains mercury. Consult your local hazardous waste regulations to dispose of this lamp in a 
proper manner.
Status
Message
The lamp has been in operation for 2000 hours. Install a new lamp for 
optimal performance. If the projector is normally run with Whisper selected 
(See 
"Getting to know the lamp hour" on page 43
), you may continue to 
operate the projector until the 2950 hour lamp warning appears.
Press ENTER to dismiss the message.
The lamp has been in operation for 2980 hours. It is strongly recommended 
that you replace the lamp at this age. The lamp is a consumable item. The 
lamp brightness diminishes with use. This is normal lamp behavior. You can 
replace the lamp whenever you notice that the brightness level has 
significantly diminished. If the lamp is not replaced beforehand, it should be 
replaced after 2950 hours usage.
Press ENTER to dismiss the message.
The lamp has been in operation for 3000 hours. The lamp MUST be replaced 
before the projector will operate normally. 
Press ENTER to dismiss the message.
OK
NOTICE: Order replacement lamp
Lamp > 2000hrs
WARNING
OK
NOTICE: Order replacement lamp
Lamp > 2980hrs
WARNING
NOTICE: Replace lamp now
Lamp > 3000hrs
Lamp-usage time exceeded
Replace lamp (refer to User Manual)
then reset lamp timer
OK
WARNING
W20000-en.book  Page 44  Monday, October 22, 2007  3:35 PM