Benq SH940 Manual De Propietario

  37

  Using the projector

En

glish

 allow you to manage the projector from a computer using a web browser when the 

computer and the projector are properly connected to the same local area network.

1. Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector and the other end 

to the RJ45 port.

2. Press MENU on the projector or MENU/EXIT on the remote control and then press  /  until 

the Advanced Setup menu is highlighted.

3. Press  

to 

highlight 

Lan Control Settings and press ENTER. The Lan Control Settings page is 

displayed.

4. Press  

to 

highlight 

Control By and press  /  to select RJ45.

5. Press  

to 

highlight 

DHCP and press  /  to select On.

6. Press  

to 

highlight 

Apply and press ENTER.

7. Please wait for around 15 - 20 seconds, and then re-enter the Lan Control Settings page.
8. The 

, 

, Default Gateway, and DNS Server settings will be 

displayed. Note down the IP address displayed in the Projector IP Address row.

1. Repeat steps 1-4 above.
2. Press  

to 

highlight 

DHCP and press  /  to select Off.

3. Contact your ITS administrator for information on the Projector IP Address, Subnet Mask, 

Default Gateway, and DNS Server settings.

4. Press   to select the item you want to modify and press ENTER.
5. Press  /  to move the cursor and then press  /  to enter the value.
6. To save the setting, press ENTER. If you do not want to save the setting, press MENU/EXIT on the 

remote control or EXIT on the projector.

7. Press  

to 

highlight 

Apply and press ENTER.

Once you have the correct IP address for the projector and the projector is on or in standby mode, you 
can use any computer that is on the same local area network to control the projector.

1. Enter the address of the projector in the address bar of your browser and click Go.

SH940_EN.book  Page 37  Wednesday, October 3, 2012  2:36 PM