Benq Digital Projector LW61ST Manual De Propietario

Operation

Adjusting the projected image

Adjusting the projection angle

The projector is equipped 2 adjuster feet. These adjusters change the image height and

projection angle. To adjust the projector:

Screw the adjuster feet to fine-tune the

horizontal angle.

To retract the feet, screw the adjuster feet in a

reverse direction.

If the projector is not placed on a flat surface or

the screen and the projector are not

perpendicular to each other, the projected

image becomes trapezoidal. To correct this

situation, see

for details.

Auto-adjusting the image

In some cases, you may need to optimize the picture quality. To do this, press AUTO on

the projector or remote control. Within 3 seconds, the built-in Intelligent Auto

Adjustment function will re-adjust the values of Frequency and Clock to provide the best

picture quality.

The current source information will be displayed in the corner of the screen for 3 seconds.

This function is only available when PC signal (analog RGB) is selected.

Fine-tuning the image clarity

Sharpen the image by rotating the focus ring.

Do not look into the lens while the

light source is on. The strong light

from the light source may cause

damage to your eyes.
Be careful when you press the quick-

release button as it is close to the

exhaust vent where hot air comes

from.