Beltronics STi-R Plus NA Guía De Instalación Rápida

Front Radar Receiver

(Continued)

4 Plug the Radar Receiver into the harness and

route the cable toward the interior of the vehicle.

Secure the cable with zip-ties. Although

waterproof, it is best to locate the inline connector

in a dry area protected from moving parts, road

debris, and hot surfaces such as the radiator and

radiator hoses.

5 Find a suitable entry point into the vehicle’s

interior. Refer to the Installation Tips section.

6 Feed the harness into the vehicle’s interior and to

the Interface. Plug into the connector labeled “Front

Receiver.”

(Continued on page 10)

Interface

1 Install the Interface under the dash using

supplied zip-ties.

Note:

Do Not Mount In Engine Compartment.

2 Connect black wire (-) to ground, and red-striped

wire (+) to a switched 12-volt supply. (If STiR PLUS

is left in the “on” position, it will automatically

power on and off with the ignition). Use blue 3M

connector (provided) to tap into an existing circuit if

needed.

3 Radar Receiver, Display, Controller, GPS Antenna,

Speaker, Concealed Alert Indicator and Radio Mute

Cable all plug into the Interface. The connectors are

labeled and are color-coded to match a stripe on

each cord. Be sure that all components are plugged

into the correct connector before applying power to

unit.

4 It is recommended that after the Interface is

installed and connected to power, all other

components are plugged in and tested for proper

operation before completing the installation.

Front Radar Receiver

White Stripe

1 Determine the best location for the Radar

Receiver. The best location is typically under the

bumper or inside the front grille of the vehicle. For

the best radar performance install the Radar

Receiver with the label facing up and the arrow

pointing forward, and provide a clear “view” of the

road (see photo at right).

2 Using the supplied U-shaped bracket and the

right-angle mounting bracket, mark the mounting

location. Drill pilot holes in the vehicle if necessary.

3 Mount the Radar Receiver using the supplied

hardware. It is recommended that the Radar

Receiver is secured to the brackets first, and then

the brackets and Receiver mounted to the vehicle.