Behringer PRO HA4600 Manual De Usuario
6
POWERPLAY PRO HA4600
1. INTRODUCTION
+
If the unit is damaged, please do not return it to us, but notify your dealer and the shipping
company immediately, otherwise claims for damage or replacement may not be granted.
Shipping claims must be made by the consignee.
Be sure that there is enough space around the unit for cooling and please do not place the POWERPLAY PRO
on high-temperature devices such as power amplifiers, etc. to avoid overheating.
+
Before connecting the POWERPLAY PRO to the mains, please carefully check that your
equipment is set to the correct supply voltage!
The fuse holder on the female mains connector has 3 triangular markings. Two of these triangles are opposite
each other. The HA4600 is set to the operating voltage shown next to these markings. It can be set to another
voltage by turning the fuse holder through 180°. CAUTION: this does not apply to export models, which
were designed e.g. only for a mains voltage of 115 V!
Connection to the mains is made by means of a mains cable with an IEC receptacle which complies with the
Connection to the mains is made by means of a mains cable with an IEC receptacle which complies with the
appropriate safety regulations.
+
Please note that all units must be grounded properly. For your own safety, you should never
remove any ground connectors from electrical devices or power cords or render them
inoperative.
WARNING!
+
It should be pointed out, that extreme output volumes may damage your ears and/or your
headphones. Turn down all LEVEL controls before you switch on the unit. Always pay
attention to an appropriate volume.
2. CONTROL ELEMENTS
The BEHRINGER POWERPLAY PRO has four identical channels. Each channel has three illuminated
push-button switches, four rotary controls, two jacks and eight LEDs. The common main section has one
control, one jack and five LEDs.
2.1 The front panel control elements