Behringer X32 DIGITAL MIXER Manual De Usuario

X32 DIGITAL MIXER Preliminary User Manual

(3)

(6)

(4)

(2)

(5)

(1)

(1) 

PREAMP – Adjust the preamp gain for the selected channel with the 

Gain knob. Press the 48 V button to apply phantom power for use  with 

condenser microphones and press the     button to reverse the channel’s 

phase. The meter displays the selected channel’s level. Press the Low Cut 

button and select the desired high-pass frequency to remove unwanted 

lows. Press the View button to access more detailed parameters on the 

Main Display. 

(2) 

GATE/DYNAMICS – Press the Gate/Ducker button to engage the noise gate 

and adjust the threshold accordingly. Press the Comp/Exp button to engage 

the compressor and adjust the threshold accordingly. When the signal level 

in the meter drops below the selected Gate threshold, the noise gate will 

silence the channel. When the signal level reaches the selected Dynamics 

threshold, the peaks will be compressed. Press the View buttons to access 

more parameters on the Main Display. 

(3) 

EQUALIZER – Press the Equalizer button to engage this section. 

Select one of the 4 frequency bands with the High, High Mid, Low Mid, 

and Low knobs. Press the Mode button to cycle through the types of EQ 

available. Select the specific frequency to be adjusted with the Freq knob, 

and adjust the bandwidth of the EQ with the Q knob. Finally, boost or cut 

the selected frequency with the Gain knob. Press the View button for more 

editing options. 

(4) 

BUS SENDS – Quickly adjust the bus sends by selecting one of the 4 banks, 

followed by one of the 4 knobs. Press the View button for more detailed 

editing and routing. 

(5) 

USB RECORDER – Connect a thumb drive to install firmware updates and to 

record performances. See the Topic Guide section for details. 

(6) 

MAIN BUS – Press the Mono Bus or Stereo Bus to assign the channel to the 

main mono or stereo bus. When Stereo Bus is selected, the Pan/Bal adjusts 

the left-to-right positioning. Adjust the overall send level to the Mono Bus 

with the Level knob. Press the View button for more editing options.