Barco E-2320 C (SE) Manual De Usuario
Attaching the display to an arm
47
Attaching the display to an arm
The panel, standard attached to the tilt & swivel foot, is
compatible with the VESA 100 mm standard. So it can be used
with an arm stand according to the VESA 100 mm standard.
compatible with the VESA 100 mm standard. So it can be used
with an arm stand according to the VESA 100 mm standard.
Therefore, the tilt & swivel foot must be removed from the
panel.
panel.
Important:
•
Use an arm that is approved by VESA (according to the
VESA 100 mm standard).
VESA 100 mm standard).
•
Use an arm that can support a weight of at least 13 kg
(28.66 lbs).
(28.66 lbs).
To attach the display to an arm stand:
1. Put the display face down on a clean and soft surface. Be
careful not to damage the panel screen.
2. Remove the tilt & swivel foot cover.
3. Remove the small screw (A) fixing the small plastic cover
on top of the foot. Next, remove the small cover itself.
Figure 17: Display with tilt & swivel foot cover removed
A
B