Burnham Series 5B Boiler Instruccion De Instalación

Descargar
Página de 112
3
improper installation, adjustment, alteration, service or maintenance can cause property damage, personal 
injury or loss of life.  Failure to follow all instructions in the proper order can cause personal injury or 
death.  Read and understand all instructions, including all those contained in component manufacturers 
manuals which are provided with the appliance before installing, starting-up, operating, maintaining or 
servicing this appliance.  Keep this manual and literature in legible condition and posted near appliance 
for reference by owner and service technician.
This boiler requires regular maintenance and service to operate safely.  Follow the instructions contained 
in this manual.  
installation, maintenance, and service must be performed only by an experienced, skilled and knowledgeable 
installer or service agency.     
All heating systems should be designed by competent contractors and only persons knowledgeable in 
the layout and installation of hydronic heating systems should attempt installation of any boiler.
it is the responsibility of the installing contractor to see that all controls are correctly installed and are 
operating properly when the installation is completed.
Installation is not complete unless a pressure relief valve is installed into the specified tapping on the 
supply manifold located on top and at rear of appliance - See Section iii, Paragraph 33, ‘e’ of this manual 
for details.
This boiler is NOT suitable for installation on combustible flooring. 
Do not tamper with or alter the boiler or controls.  Retain your contractor or a competent serviceman to 
assure that the unit is properly  adjusted and maintained.
clean boiler at least once a year - preferably at the start of the heating season to remove soot and scale.  
The inside of the combustion chamber should also be cleaned and inspected at the same time.
Have Burner and controls checked at least once a year or as may be necessitated.  Do not operate 
unit with jumpered or absent controls or safety devices.  Do not operate unit if any control, switch, 
component, or device has been subject to water.