Bühler 2596 Manual De Usuario

bühler 

 

Allied Front-End Loader 

 

 

- 23 - 

P4094 

MAINTENANCE 
 
General Inspection: 

 

 

Lower attachment and loader to ground, place all 

controls in neutral, stop engine, set parking brake and remove ignition key before 
inspecting, servicing, adjusting or repairing loader. 
 

Relieve hydraulic pressure before repairing, adjusting 

or disconnecting hydraulics components.  Escaping hydraulic oil can penetrate 
skin causing serious personal injury.  If injured consult a physician immediately. 

 

Never work beneath a raised loader unless it is 

securely supported.  The control lever can be moved or a hydraulic leak could 
cause the loader to drop resulting in serious injury or death.  Refer to the Lift 
Lock Instructions Decal for proper use of the lift locks. 
 
 
Lift Locks:  The lift locks on your loader are to be used whenever someone is 
attempting to be under the loader or for tractor servicing.  When using the locks 
ensure loader is free of any load in the loader attachment or no attachment. 
 

 
 
To engage, raise loader sufficient for lift lock 
clearance.  Swing each lift lock forward 
resting on the cylinder rod below the head 
plate as shown.  Turn off the tractor and 
slowly lower the loader until the cylinder head 
plate rests up against the lift lock.  Then lock 
joystick in neutral position. 
 
 
 

 
Pins and Bushings:  Every 6 months or 1000 hours check loader and cylinder 
pivots for movement that would be due to bushing or pin wear.  Change bushings 
when excessive movement is noticed and replace any worn or rough surfaced 
pins.