Bravo View IND-5000BT Manual De Usuario

Descargar
Página de 30
22
Installation Guide
Preparation
1. Disconnect battery
Before  you  begin,  always  disconnect  the 
battery negative terminal.
 
Note:
If the unit is to be installed in a car equipped 
with an on-board drive or navigation computer, 
do  not  disconnect  the  battery  cable.  If  the 
cable is disconnected, the computer memory 
may be lost. Under these conditions, use extra 
caution during installation to avoid causing a 
short circuit.
2. Remove transport screws
          IMPORTANT:
 
            Remove these two transport screws 
before  installation.  Otherwise,  the 
DVD player will not work.
3. Remove unit from sleeve
Lift latches on both sides of sleeve to remove 
half-sleeve from the unit.
Mounting Sleeve Installation
1. Slide the mounting sleeve off the chassis. 
If it is locked into position, use the removal 
tools (supplied) to disengage it.
2.  Check  the  dashboard  opening  size  by 
sliding the mounting sleeve into it.
            
   If the opening is too small, carefully cut or 
file  as  necessary  until  the  sleeve  easily 
slides into the opening. Do not force the 
sleeve into the opening or cause it to bend 
or bow. Check for sufficient space behind 
the dashboard for the unit chassis.
    This unit can be installed in any dashboard 
with a suitable 183 mm (W) x 52 mm (H) 
opening as shown above. The dashboard 
should be 4.75 mm - 5.56 mm thick in order 
to be able to support the unit.
3. Locate the series of bend tabs along the 
top,  bottom,  and  sides  of  the  mounting 
Device Connections
Using the ISO Connector
1.  If  your  car  is  equipped  with  the  ISO 
connector, then connect the ISO connectors 
as illustrated.
2 .   F o r   c o n n e c t i o n s   w i t h o u t   t h e   I S O 
connectors, check the wiring in the vehicle 
carefully  before  connecting,  incorrect 
connection may cause serious damage to 
this unit. 
      Cut  the  connector,  connect  the  colored 
leads of the power cord to the car battery, 
as shown in the colour code table below for 
speaker and  power cable connections. 
Location
Connector A
Connector B
Rear Right (+) - Purple
Rear Right (-) - Purple / 
Black Stripe
Front Right (+) - Gray
Front Right (-) - Gray / 
Black Stripe
Front Left(+) - White
Front Left(-) - White / 
Black Stripe
Rear Left (+) - Green
Rear Left (-) - Green/          
        Black Stripe
1
2
3
4
5
6
7
ACC+/Red
ANT/Amp control
/Blue
Battery 12V(+)/Yellow
Ground/Black
8
Function 
Telephone Mute/Pink