Bracketron Multi Vehicle Mount MVM-15-05 Manual De Usuario

MVM Instructions | 

IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers 

seat vantage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic 

parts of a vehicles dash. 

Unnecessary force or pressure can cause pieces to crack or break.

PARTS INCLUDED: MVM-15-05 Mount, 3- #8x3/4” Self Tapping Screws PHS-203 Ultra Slim Swivel, and Hardware

TOOLS NEEDED FOR MVM MODIFICATION (if required)

4 inch Mounted Bench Vise

12 oz. Ball Pein Hammer

Standard Tin Snips

Small File

Dash Trim Tool (Part #SIT-104)

7mm Socket and Driver

9/32” Open End Wrench (for swivel)

#2 Phillips Screwdriver

Begin installation by removing the bezel that surrounds the radio and climate 

control. There are 5 metal retainer clips around the perimeter and 3 plastic 

clips near the top that secure this bezel. When bezel is removed, set it aside 

carefully.

Skip to Step 5 on the following page if you have not yet formed the bracket 

to fit your vehicle.

 

With a Phillips screwdriver (or 7mm socket and driver), locate and remove 

the screw directly to the right side of the climate control. Set the screw aside. 

Place the MVM over the screw hole and replace factory screw. Note: Make 

sure the MVM is resting tightly against the right side of the dash bezel

Carefully reinstall the dash in reverse order securing the dash bezel into its 

original position. Note: You will feel and hear a “click” when all 8 clips are 

secured.

If Desired, Install the included Ultra Slim Swivel #PHS-203 to your Multi 

Vehicle Mount or any other AMPs compatible device.

Your installation is complete

Install Mount Here

Note:

 The hole pattern on the face of the MVM maybe 

different then what is shown in the pictures.