Bosch Appliances Radio SC3100 Manual De Usuario
SC3100
System Initialization
SC3100 Operation and Installation Guide
© 2004 Bosch Security Systems
Page 21
90026-201D
5.0 System
Initialization
The following describes the System Initialization Procedures for the SC3100 Radio communicator.
5.1
System Initialization Procedures
Contact the Central Station SAFECOM computer operator. Then verify that the following information is entered in
the SAFECOM SC9000 computer account for the specific SC3100 you are working on.
the SAFECOM SC9000 computer account for the specific SC3100 you are working on.
You must build an account into the SAFECOM SC9000 computer before the computer will recognize and place
on-line a unit in the field. Below is a summary of the parameters necessary to program an SC3100 account into
the SAFECOM computer. This is the first setup menu. These parameters must be entered, then “PG DOWN” to
the second menu. A summary of the second setup menu can be found on the following page. The parameters
that must be programmed by the Central Station are denoted in the following illustration and are summarized
below:
on-line a unit in the field. Below is a summary of the parameters necessary to program an SC3100 account into
the SAFECOM computer. This is the first setup menu. These parameters must be entered, then “PG DOWN” to
the second menu. A summary of the second setup menu can be found on the following page. The parameters
that must be programmed by the Central Station are denoted in the following illustration and are summarized
below:
02/12 10:45:57
F1= Copy
PGDN= More Setup
F2=Delete
F9=Help
I SAFECOM ST1000 v2.42 I
02/12 09:12:22 122>STARTUP
02/12 09:13:26 301>AC TROUBLE
02/12 09:14:42 152>ALARM ZONE2
02/12 09:15:57 202>2133 E1
02/12 09:13:26 301>AC TROUBLE
02/12 09:14:42 152>ALARM ZONE2
02/12 09:15:57 202>2133 E1
TX RX MODE HP
** - - - - -
** - - - - -
SAFECOM SC9000 COMPUTER
*
SELECT | REMOTE 456 | SETUP 1
S/N:
PID:
Framer:
Channel:
Poll Interval: : :
Vline:
Vaccount:
Notes:
Figure 6: System Parameters
•
S/N:
This number must match the CPU Serial Number listed on the label of the SAFECOM SC3100.
•
PID:
This number must match the PID number on the label of the SAFECOM SC3100.
•
Framer:
This should correspond to the framer that is to be assigned to this unit.
•
Poll Interval:
This is the time in hours : minutes : seconds that the unit in the field is to be polled by the
Central Station.
•
Vline:
The number placed here will report to the Automation System as coming in from “line XX”
•
Vaccount:
The number placed here will report to the Automation System as signal coming from “account
XXXX”.
•
Notes:
This area is used to note the account information such as: Address, Customer, Account #, Install
date, etc.