Binatone C350 Manual De Usuario

         

 

Here you can choose from three different route types. 

• Short: Choosing Short will result in a route that has the smallest total distance of all possible 

routes between the given points. This is usually preferred by pedestrians, cyclists or slow 

vehicles. 

• Fast: Choosing Fast will result in the quickest possible route, given that you can travel at or near 

the speed limits on all included roads. This is usually preferred for fast and normal cars. 

• Economical: This setting is a wise combination of the previous two. Although basically going for 

the fastest solution, if there is another route taking a bit more time but a lot less distance 

compared to the fastest one, Binatone Carrera will choose this one instead to save fuel. 

You can set the type of the vehicle that you will use to navigate the route. Based upon this setting, 

some of the road types will be excluded from the route (e.g. motorways for pedestrians), or some of 

the restrictions may not be taken into account (e.g. emergency vehicles have no restrictions). 

Furthermore, when Bus or Lorry is chosen, the program assumes that high speeds cannot be 

achieved, and this information is taken into account when calculating the route, the estimated time 

enroute (ETE), and the estimated time of arrival (ETA). 

Available values: 
‧

 Car 

‧

 Taxi 

‧

 Bus 

‧

 Lorry 

‧

 Emergency 

‧

 Pedestrian 

‧

 Bicycle 

 

Road types to include/exclude 

To let the route fit your needs you can also set which road types are to be considered for or to be 

excluded from the route if possible. 

 

Unpaved Roads: Unpaved roads are excluded by default, as they can be in a bad condition and 

you usually cannot reach the speed limit on them. 

 

Motorways: When driving a slow car or towing another vehicle, you may prefer not to take 

motorways. 

 

Ferries: The accessibility of temporary ferries is not necessarily included in the map data. 

Furthermore you may need to pay fare, so you may consider disabling them from the preset 

enabled status.