Balay 3TI60081A Instruccion De Instalación

20

Soiling caused by ointments, grease or 
oil

Wash the laundry using the maximum 
detergent dosage and the maximum 
permissible temperature – see the 
care label.

Amount of detergent too low.

! 

inicio/pausa (Start/Pause) button 

selected by mistake.

Press the button again to restart the 
programme.

The fabric softener is not 
completely flushed in or too 
much water remains in the 
compartment i

The fabric softener compartment insert 
is not correctly attached or is blocked.

Clean the fabric softener compartment 
insert and fit it correctly in the 
compartment i  page 15.

Power failure.

Programme will continue when power 
is restored. If washing is removed 
during a power failure, first drain off the 
water,  page 16. Check whether:

- the plug is plugged into the socket 
correctly
-the circuit breaker (fuse) has tripped. 
Call the after-sales service.

D 

(Rinse stop) selected.

Select the programme 

t

/D

 (Empty) 

and  press ! inicio/pausa (Start/

Pause).

The programme is running or the door 
is locked for safety reasons.

Wait until the End indicator light 
flashes.

Power failure.

Unlock the loading door mechanically.

Set the programme selector to 
stop (Off).

Select any programme. The washing 
machine checks whether opening the 
loading door is possible. Otherwise, 
see Programme termination 
 page 14.

In order to unlock the door mechanically in the event of a power failure, you will 
have to:

 set the programme selector to 

stop (Off) and unplug the mains plug from the 

socket.

 open the base panel and drain out the water  page 16.

 pull the emergency release downwards and open the loading door at the 

same time.
– Before opening the loading door, make sure that there is no water or hot 

washing water in the appliance.

Under no circumstances open the door with the emergency release while the 
drum is still turning.

If you cannot correct a fault yourself (switching on/off) or a repair is required:

– Set the programme selector to stop (Off) and unplug the mains plug from the socket.

– Turn off the tap and call the after-sales service  page 21.