Bakers Pride Ventless Hood System FH-28 Manual De Usuario

 

3.  If required, connect the provided fire extinguishing system contacts for remote signaling (refer to 

the electrical diagram in this manual). 
 

4.  Adjust the position of the two ADP appliance nozzles as depicted below. 

 

 

 

 

5.  Reset control head. With control head NOT connected to cylinder, dry test system by activating 

the remote pull. 
 

6.  Install cylinder by placing bottom of cylinder over socket head screws at the bottom of cylinder 

bracket. Tighten pipe union located in the discharge line. Secure cylinder with adjustable 
clamping strap. 
 

7.  Reset control head and connect control to cylinder. 

 

8.  Recheck installation procedure to insure that nothing has been overlooked. 

 

 

Electrocution, equipment failure or property damage could result if an unlicensed 
electrician performs the electrical installation. Ensure that a licensed electrician 
perform the electrical installation. 
 

 

In the event of an appliance fire, serious injury, property damage or death could 
occur if the appliance is powered from a source other than the hood. The cooking 
appliance used under this hood MUST receive its input power from the hood. In 
the event of a fire, the hood fire extinguishing system will automatically remove 
power from the connected appliance.