Whirlpool WFG540H0AW Manual De Propietario
10
Positioning Racks and Bakeware
IMPORTANT: To avoid permanent damage to the porcelain finish,
do not place food or bakeware directly on the oven door or bottom.
do not place food or bakeware directly on the oven door or bottom.
Bakeware
To cook food evenly, hot air must be able to circulate. Allow
2" (5 cm) of space around bakeware and oven walls. Make sure
that no bakeware piece is directly over another.
2" (5 cm) of space around bakeware and oven walls. Make sure
that no bakeware piece is directly over another.
Racks
■
Position racks before turning on the oven.
■
Do not move racks with bakeware on them.
■
Make sure racks are level.
To move a rack, pull it out to the stop position, raise the front edge,
and then lift out. Use the following illustration and charts as a
guide.
and then lift out. Use the following illustration and charts as a
guide.
The oven has 7 positions for a flat rack, as shown in the previous
illustration and the following table.
illustration and the following table.
*If your model has a Max Capacity Oven Rack, the recessed ends
must be placed in the rack position above the desired position of
the food. See the following illustration.
the food. See the following illustration.
IMPORTANT: These rack positions are for flat racks. If a Max
Capacity Oven Rack is used, the rack position must be adjusted as
shown in the previous figure.
Capacity Oven Rack is used, the rack position must be adjusted as
shown in the previous figure.
Multiple Rack Cooking
2-rack: Use rack positions 2 and 5 for regular baking.
2-rack (convection only): Use rack positions 2 and 5.
Baking Layer Cakes on 2 Racks
2-rack (convection only): Use rack positions 2 and 5.
Baking Layer Cakes on 2 Racks
For best results when baking cakes on 2 racks, use racks 2 and 5.
For best results when convection baking cakes on 2 racks, use
racks 2 and 5. Place the cakes on the racks as shown.
For best results when convection baking cakes on 2 racks, use
racks 2 and 5. Place the cakes on the racks as shown.
Oven Vent
The oven vent releases hot air and moisture from the oven, and
should not be blocked or covered. Blocking or covering the oven
vent will cause poor air circulation, affecting cooking and cleaning
results. Do not set plastics, paper or other items that could melt or
burn near the oven vent.
should not be blocked or covered. Blocking or covering the oven
vent will cause poor air circulation, affecting cooking and cleaning
results. Do not set plastics, paper or other items that could melt or
burn near the oven vent.
Baking and Roasting
ACCUBAKE
®
Temperature Management System
The ACCUBAKE
®
system electronically regulates the oven heat
levels during preheat and bake to maintain a precise temperature
range for optimal cooking results. The bake and broil elements or
burners cycle on and off in intervals. On convection range models,
the fan may be cycled on and off for short intervals to provide the
best results.
range for optimal cooking results. The bake and broil elements or
burners cycle on and off in intervals. On convection range models,
the fan may be cycled on and off for short intervals to provide the
best results.
Before baking and roasting, position racks according to
“Positioning Racks and Bakeware” section. When roasting, it is not
necessary to wait for the oven preheat cycle to end before putting
food in unless it is recommended in the recipe.
“Positioning Racks and Bakeware” section. When roasting, it is not
necessary to wait for the oven preheat cycle to end before putting
food in unless it is recommended in the recipe.
Preheating
When START is pressed, the oven will begin preheating. Once
100ºF (35ºC) is reached, the display temperature will increase as
the actual temperature of the oven increases. When the preheat
temperature is reached, a tone will sound, and the selected
temperature will appear on the display. The time necessary to
preheat the oven to 350°F (177°C) is approximately 10 to
15 minutes. Factors that have an impact on preheat times are:
room temperature, starting oven temperature, and the number of
oven racks. Unused oven racks can be removed prior to preheating
your oven to reduce the preheat times.
100ºF (35ºC) is reached, the display temperature will increase as
the actual temperature of the oven increases. When the preheat
temperature is reached, a tone will sound, and the selected
temperature will appear on the display. The time necessary to
preheat the oven to 350°F (177°C) is approximately 10 to
15 minutes. Factors that have an impact on preheat times are:
room temperature, starting oven temperature, and the number of
oven racks. Unused oven racks can be removed prior to preheating
your oven to reduce the preheat times.
Flat Rack Position*
Type of Food
7
Broiling/searing meats, hamburgers,
steaks
steaks
6
Broiled meats, poultry, fish
3 or 4
Most baked goods, casseroles
2
Roasted meats
1
Large roasts or poultry
7
6
5
5
4
3
2
1
A. Ends of rack in position 3
B. Food in position 2
B. Food in position 2
A
B
A. Oven vent
A