West Elm Rolling Storage Unit - 3x4 Instrucciones Para El Montaje

assembly instructions

page 12 of 12

:  rolling storage unit 3x4

OVER BALANCE.   To prevent injury and property damage from unexpected tipping of furniture, we highly recommend

    installation of the two (2) sets of overbalance protection hardware included with this product.

   1.  Attach the two mounting brackets horizontally to the top back edge of the furniture. Insert the

   2.  Determine where the furniture is to be placed and mark location on the wall for the other two

        mounting bracket screw holes. It should be placed approximately 2” below the bracket mounted

        to the furniture.

   3.  Attach the two mounting brackets vertically to the wall by inserting the long screws provided through 

        the holes in the bracket and tightening securely using screwdriver.

        short screws through the holes in the bracket and tighten securely using screwdriver.

   4.  Place the furniture so the brackets on the back edge are in line with the brackets on the wall.

   5.  Lace an end of the nylon restraint strap down through each bracket. Bring both ends together

        and slide the thin end of the strap through the receiving end of the strap until snug.

   6.  Check to make sure the strap is securely laced and locked to the brackets.

   7.  Repeat steps 5 and 6 for the second bracket set.

back side

wall

6889810/6813257/6813398/9740754/9740523 - 07/07