Wasp Bar Code WPA1200 Manual De Usuario

 

14 

3.  Push the card into the slot until you hear an audible system sound; this will signal that the card is already 

properly seated within the slot.  

The card is secured when it is not protruding from the slot. 

 

Removing a Storage Card 

1.  Remove the two screws from the SD compartment cover and remove the cover. 
2.  Press the card in and release.  
3.  The card pops out. An audible system sound will signal that the card has been released. 
4.  Remove the card from the slot. 
 
 

The WPA1200 has an integrated laser scanner that reads all major bar code labels. 
Note: Scanning software must be enabled in order to operate the scanner. This can be a user-loaded application 
or a pre-loaded utility such as Scanner Setting. 
Activate the laser scanner by pressing either one of the trigger keys located on the left and right side of the unit.  
The WPA1200 has a built-in Scanner Setting utility that allows you to test the device’s barcode scan function. 

 

 

1.  To launch Scanner Settings, tap Start 

→ Settings → System → Scanner Settings.