Wolverine Soffit and Decorative Trim Manual De Usuario

Extra-wide cornerposts give you a distinctive, easy-to-install
method of finishing outside corners. Each cornerpost consists
of four parts: Corner starter, two lineals and a 1/4 round 
snap-in molding.

Lineals are available in two board styles: 5" smooth and 
3-1/2" smooth.

The installation procedure is identical for all lineals and inserts.
To install this four-part accessory, follow these steps:

Cut cornerpost pieces. Measure the vertical span, and allow 
1/4" clearance from the underside of the eave and 3/4" below
the starter strip. Cut all four pieces using a power circular saw.

Hang a starter strip. Position the starter strip, leaving 1/4"
allowance for expansion at top and 3/8" at bottom. Position
the first nail at the uppermost edge of top nail slot (shown).
Nail loosely. Working from top down, position remaining nails
every 8"-10", with nails centered in slots.

Attach side lineals. Lock the first lineal into the starter strip.
Nail to the sheathing following the procedure described above.
Repeat the process for the other lineal.

Snap in the quarter-round corner insert. Working from the
bottom up, begin by inserting the longer leg of the insert into
the nail flange side of the starter strip first, then snap in the
shorter leg. Lightly press along the length of the molding as
you snap it into place.

30