Wolverine Soffit and Decorative Trim Manual De Usuario
Measure the side casing and add 7". Use a triangle to create a
45˚ angle or measure 3-1/2" in from the edge of the part. Use
snips or a miter saw to remove this portion.
45˚ angle or measure 3-1/2" in from the edge of the part. Use
snips or a miter saw to remove this portion.
Flip the part over and remove the locking leg as shown. This
should be done to both ends.
should be done to both ends.
Snap the lineal over the J-channel as shown. Use the same
measurements for both sides.
measurements for both sides.
Corner blocks
Install J-channel around the perimeter of the window opening.
J-channel should be the same length as the casing.
J-channel should be the same length as the casing.
Install corner blocks on all 4 corners as shown. Leave blocks
loose until the lineals are installed.
loose until the lineals are installed.
Cut the lineals the same length as the window casing.
Start with one end and angle a lineal into the corner block and
snap it over the J-channel.
snap it over the J-channel.
Continue installing lineals around the window.
Crown molding
Crown molding will fit over the top of the lineal system.
Install J-channel and lineals around window casing.
Measure the top lineal and add 2-1/2". This will be the crown
molding length.
molding length.
Insert crown molding cap into the crown molding and trace
the shape. Trim off the marked line.
the shape. Trim off the marked line.
The crown molding requires a tab 2" long – cut from the
pocket receiver as shown.
pocket receiver as shown.
Cut the crown molding cap in half and apply the halves with a
bead of caulk.
bead of caulk.
Insert the crown molding into the top of the lineal as shown.
40
Wolverine Fit and Finish Installation Guide