Wolverine Soffit and Decorative Trim Manual De Usuario
5" Square Header with Endcaps over
3-1/2" Lineals Sides and Bottoms
3-1/2" Lineals Sides and Bottoms
Assemble 5" header and cap. The side 3-1/2" lineals should
extend approximately 1" inside the header assembly.
extend approximately 1" inside the header assembly.
Finish the corner by sliding the 3-1/2" side lineals behind the
header, making sure the 2" rain tab on the end cap extends
into the receiving area of the side lineals.
header, making sure the 2" rain tab on the end cap extends
into the receiving area of the side lineals.
NOTE: If using crown molding, see page 50.
47
Wolverine Fit and Finish Installation Guide
1-1/2" - 1-3/4"
slit in pocket
area of the
3-1/2" side
lineals
slit in pocket
area of the
3-1/2" side
lineals
3-1/2"
1-1/8"
5" lineal
header
header
removing this
section allows
side 3-1/2" lineal
to slide behind
the 5"
section allows
side 3-1/2" lineal
to slide behind
the 5"
2" rain tab
end cap
(from 5"
lineal)
(from 5"
lineal)
3/4"
3/4" rain tab