Woodstock Shop Fox Fence W1410 Manual De Usuario

Shop Fox

Fence

-13-

Step 10.

Increase the clamping force by unscrewing the

longer yoke (#22) half a turn and retest. If more

adjustment is required, screw the shorter yoke

(#10) in half a turn. If further adjustment is

required, continue to work back and forth between

the two yokes so that both are adjusted equally.

Step 11.

To reduce the clamping force, screw the longer

yoke in or the shorter yoke out.

Step 12.

Reinstall all pivot pins and cotter pins and test the

clamping force of the entire unit. Locking lever

pressure should not exceed 20 pounds. The fence

should be able to withstand approximately 50

pounds of lateral force.

CAUTION: Through repeated use and wear, re-

adjustment of the front and rear clamps and

handle throw may be necessary for safe operation

and maximum performance.

Step 8.

Push down the locking lever and test the grip of

the rear clamp by pushing from side to side on the

back end of the fence. If the clamp holds securely

under a lateral force of 25 pounds, the rear clamp

requires no further adjustment. If the rear clamp

slips under 25 pounds of lateral force, adjustment

will be necessary.

Step 9.

To adjust the rear clamp, first remove the clamp

assembly from the two yokes by removing the two

cotter pins and pivot pins (#8 & 16). Figure 16.

Step 6.

Once the front clamp is properly adjusted, rein-

stall both cotter pins. If the front clamp cannot

be made to function properly, refer to Section V,

Troubleshooting on page 20.

Step 7.

The procedure for adjusting the rear clamp is vir-

tually identical to the procedure for adjusting the

front clamp. Disable the front clamp by temporar-

ily removing the cotter pin and pivot pin in the

front clamp assembly. Figure 15.

Figure 15. Disabling the front clamp.

Figure 16. Removing clamp assembly.

Remove