Woodstock Shop Fox Fence W1410 Manual De Usuario

Shop Fox

Fence

-5-

SECTION II: INSTALLATION

Figure 1. Attaching the back rail.

C. MOUNTING THE RAILS

Step 1.

Locate the back fence rail (the rail with the oval

cut-outs) and set it against the rear edge of the

table saw. Position the back rail so that its top

edge is

⁄

" below the table top and the oval cut-

outs are in line with the miter slots. Figure 1. If the

back rail mounting holes line up with the existing

holes in the table top, attach the rail using the

original mounting hardware as shown in Figure

3. If the holes do not line up, use the mounting

method covered in Steps 3-6.

A. ORDER OF INSTALLATION

Installation of the Shop Fox

Fence is quick and

easy. Installation involves mounting the front and

back rails to your table saw and then attaching

the fence to the rails. On some saws, the mount-

ing holes for the rails will match the existing rail

mounting holes. On other saws where the mount-

ing holes do not line up, it will be necessary to

drill and tap new mounting holes in your table top

edge. We’ve supplied you with a drill and tap for

this purpose. If you are uncomfortable with the

tapping process, through-bolting may be used as

an alternative. If through-bolting, make sure you

have access to the backside of the hole and that the

table webbing will not interfere with the nut and

bolt before attempting this method.

Before beginning installation, measure your table

saw top from front to back. The Shop Fox

Fence

comes preset to fit on tables measuring between

⁄

'' and 27

⁄

''. If your table top is not within

this range, refer to the Troubleshooting Guide for

further instruction.

B. TOOLS REQUIRED

Only a few common tools are required to assemble

your Shop Fox

Fence. Specifically, these are:

14mm open end wrench

5mm Allen wrench

3mm Allen wrench

Regular screwdriver

6" adjustable wrench

Needle nose pliers

⁄

'' socket and ratchet

Optional Tools:

⁄

''-16 tap

⁄

'' drill bit

⁄

'' drill bit

⁄

'' or

⁄

'' Electric drill

Center punch

Hammer

Tap handle

Step 2.

Line up the ends of the front rail even with the

back. Set the top edge

⁄

" below the bottom of

the miter slots. Figure 2. If the front rail mounting

holes line up with the existing holes in the table

top, attach the rail using the original mounting

hardware as shown in Figure 3. If the holes do

not line up, use the mounting method covered in

Steps 3-6. If both rails are mounted at this point,

skip to Step 7.

Note: Delay installation of the adhesive scale

(#56) until Section III Part G.