Woodstock SHOP FOX W1677 Manual De Usuario

-42-

W1677/W1711 10" Table Saw

9. Slightly rotate the table in the appropriate direction.

Recheck the measurements you did in

Steps 3 & 6.

10. When you have adjusted the table so both measure-

ments are the same, tilt the blade to 45˚ and mea-

sure the distance from the miter slot to the blade as

done in

Steps 2–5.

— If these measurements are the same, tighten the

table mounting bolts, then recheck to make sure

the table did not move during tightening. No fur-

ther adjustments are necessary.

— If either of these measurements are different from

the other, then the table needs to be shimmed

with metal shim stock at the table mounting loca-

tions. Proceed to the next step.

11. First determine which measurement is longer. If

measurement “A” (

Figure 68) is shorter, then cor-

ners #1 and #2 need to be shimmed.

12. If measurement “B” (Figure 69) is shorter, then cor-

ners #3 and #4 need to be shimmed.

13. Place equal sized pieces of metal shim stock under

each of the corners that need to be shimmed.

Repeat this until the distance from the miter slot to

the blade is equal at both the front and back.

14. Set the blade to 90˚ and make sure the miter slot is

still parallel to the blade.

15. Tighten the table mounting bolts and recheck mea-

surements. Adjust if necessary.

��

��

�

Figure 68. Measuring blade to miter slot

at point A.

��

��

�

Figure 69. Measuring blade to miter slot

at point B.

Figure 70. Shimming table with masking

tape.

To shim an extension wing, do these steps:

1. DISCONNECT SAW FROM POWER SOURCE!

2. Remove the extension wing from the table.

3. If the extension wing tilts up, place a few layers of

tape above the wing mounting bolt holes as shown

Figure 70. If the extension wing tilts down, place

the tape below the bolt holes.

4. Reinstall the extension wing on the table, trim any

projecting tape, and check to see if the table is flat.

Repeat as necessary until the extension wing creates

one flat surface with the main table.

Shimming Wings

Masking Tape