Woodstock M1039 Manual De Usuario

-14-

+%  Place the rack inside of the table bracket, mesh it 

together with the pinion, and slide the table sup-
port/rack assembly over the column, as shown in 
=`^li\((.

,%  Slide the column ring over the column with the bev-

eled edge facing down (

=`^li\()), fit the beveled 

edge of the column ring over the rack, and tighten 
the setscrew. 

 

Efk\1 DXb\jli\k_\iXZb`jj\Xk\[]`idcp`ek_\
cfn\ii`e^Y\]fi\k`^_k\e`e^k_\j\kjZi\n%;fefk
fm\i$k`^_k\ek_\j\kjZi\nfipfldXpjgc`kk_\Zfc$
ldei`e^%

-%  Install the crank handle over the pinion shaft, and 

tighten the setscrew in the crank handle against the 
flat part of the pinion shaft.

.%  Thread the handle into the crank handle.

/%  Thread the large lock lever into the back of the 

table bracket approximately three turns, for now.

 
0%  Thread the small lock lever into the front part of 

the table bracket approximately three turns, for 
now. The assembly should now be assembled as 
shown in 

=`^li\(*.

=`^li\((% Sliding table bracket and rack 

over column.

=`^li\()% Correct column ring 

orientation.

=`^li\(*% Handles and lock levers 

installed.

Large Lock 

Lever

Crank Handle

Small Lock 

Lever