Woods Equipment 872500G Manual De Usuario

The rear outside deck rollers are adjustable up and 

down to provide improved deck flotation and scalp-
ing protection at various heights of cut.  They are not 
intended to ride continuously on the ground.  Adjust 
no closer than 3/8” (10mm) to the ground.

The height of cut is set by moving height of cut pin C 
to the hole designated for the height of cut desired.  

To change the height of cut:
1.  Lift the deck to the highest position.
2.  Move pin C to the selected hole.  
3.  Lower the deck until the lift lever is stopped by 

the pin.

NOTES:  

– 

Height of cut may vary due to the amount of 

tread on the tires, tire diameter or inflation pres-
sure.

– 

For best results, adjust the rear deck rollers for 
the height of cut to be used (see below).

 

1.  Raise the cutterdeck all the way.

2.  Adjust the spring A with nut B: The spring length 

should be set at approximately 8-3/4", inside loop 
to inside loop, when in transport position.

 

The springs may be tightened or loosened from 
this point according to personal preference.