White Outdoor 500 Manual De Usuario

1.  For shipping purposes, the chute deflector on your 

mower is held in an upright position by a retainer. 
Remove the retainer as follows:
a.  Push  chute deflector up towards engine. Holding 

deflector in this position, remove the retainer and 
discard. See Step 1.

b.  Lower the chute deflector carefully keeping your 

fingers out of the way.

2.  Perform the following sequence for handle setup:

a.  Lift the upper handle up from the folded position to 

the extended position following the arrow in Step 2. 
The handle should click into this position.

b.  Make sure the carriage bolt is seated properly 

in the handle. Tighten wing nuts securing upper 
handle to the lower handle

3.  If satisfied with height of handle, tighten wing nuts 

at the ends of the lower handle shown in Step 3. For 
convenience of operating, you may adjust the handle 
height as follows:
a.  Remove the wing nuts shown in Step 3 and remove 

the lower handle.

b.  Position each handle bracket stud into the top hole 

in the lower handle. See Step 3 inset.

c.  Tighten the wing nuts. 

4.  Insert post on cable ties into holes provided on the 

lower handle. Pull cable tie tight and trim excess. See 
Step 4.

Your mower is shipped 
with the handle in the 
higher height position.

NOTE: Each end of 
the lower handle must 
be placed in the same 
relative position.

This unit is shipped 
without gasoline or 
oil in the engine. Fill 
up gasoline and oil 
as instructed in the 
accompanying engine 
manual 

operating your mower.

The chute retainer 
must be removed and 
discarded before 
operating the mower.

�

�

��

�

�

�

�