White Outdoor RB650 Manual De Usuario

Descargar
Página de 20
12
CLEANING THE TINE AREA
Clean the underside of the tine shield after each use. 
The dirt washes off the tines easier if washed off 
immediately instead of after it dries.
We do not recommend the use of pressure washers to 
clean your unit. They may cause damage to electric 
components, spindles, pulleys, bearings, or the engine. 
The use of pressure washers will result in shortened life 
and reduce serviceability.
BELT REPLACEMENT
CAUTION: 
Do not use an off-the-shelf
belt.
Your tiller has been engineered with a belt made of 
special material (Kevlar Tensile) for longer life and 
better performance. It should not be replaced with an 
off-the-shelf belt.
If belt replacement is required, order belt by part 
number from your nearest authorized dealer.
Part No. 754-0434—‘‘V’’ Belt
Disconnect and ground the spark plug wire against 
the engine.
Remove the belt cover from the left side of the tiller 
as follows: See Figure 10.Remove two torx screws 
from the top of belt cover.
Remove the hex cap nut and flat washer from the 
side of the belt cover. Remove the self tap screw at 
the bottom of the front of the cover.
Remove the belt keeper bracket located behind the 
engine pulley by removing two hex bolts and lock 
washers. See Figure 11.
Remove belt. Reassemble new belt, following 
instructions in reverse order.
Figure 10
Upon reassembly, make certain the belt is routed over 
the idler pulley and inside of belt keepers by engine 
pulley. See Figure 11.
Figure 11
TIRES
Recommended operating tire pressure is 
approximately 20 p.s.i. (check sidewall of tire for tire 
manufacturer’s recommended pressure). Maximum tire 
pressure under any circumstances is 30 p.s.i. Equal tire 
pressure should be maintained on both tires.
When installing a tire to the rim, be certain rim is clean 
and free of rust. Lubricate both the tire and rim 
generously. Never inflate to over 30 p.s.i. to seat beads.
WARNING: 
Excessive pressure (over 30
p.s.i.) when seating beads may cause tire/
rim assembly to burst with force
sufficient to cause serious injury.
Torx Screws
Belt Cover
Hex Cap Nut
Self Tap
Screw 
Flat Washer
Engine
Pulley
Belt Keeper 
Idler
Brkt.
Idler
Pulley
Rod
     Brkt.